Skip to main content
Skip table of contents

Running Multiple Reports Simultaneously

Note: This functionality is available in Version 9.2.4 and higher.

Some reports can be submitted and run simultaneously. On the Reports > State Reports page, reports with multi-submit functionality display a checkbox to the left of the report as well as a checkbox on the heading under which the report resides.

You can run single reports or multiple reports at one time. You can also select a heading's checkbox to run all the reports under that heading at once.

All multi-submit reports have report parameters preset as defaults. These defaults are used when you run multiple reports simultaneously; however, you can change these parameters at any time. You can also set new parameter defaults when required.

To run multiple reports simultaneously:

  1. On the Start Page, click System Reports. The Reports page appears.
  2. Click the State tab. The State Reports page appears.
  3. (Optional) To change parameters before running the report:
    1. Open the multi-submit report to be run and set the report parameters.
    2. Under Scheduling, click Schedule and enter a date and start time.
      Note: Allow enough time to set the parameters for all the other reports you want to run simultaneously.
    3. Click Submit. The State Report page appears.
    4. Repeat steps 3-5 for each multi-submit report for which you want to change the parameters.
  4. On the State Reports page, click the checkbox next to each report you want to run, or click a heading checkbox to run all the multi-submit reports under that heading.
  5. Click Submit.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.