Skip to main content
Skip table of contents

State Reporting Platform

Some Idaho reports use the State Reporting Platform (SRP), which optimizes the performance of the report. SRP reports are on the Run Reports > State Reports tab and appear at the bottom of the page. The SRP report output is available in Report Queue > ReportWorks.

Setup is required to support SRP reports. Districts need to configure ReportWorks Preferences if you have not already done so. Additional information for configuring for the State Reporting Platform is available in article 62620 on PowerSource.

  • If you have already configured ReportWorks Preferences, no additional setup is required.
  • If you have not configured ReportWorks Preferences, please refer to the "ReportWorks Preferences" section of the ReportWorks Setup and Administration Guide on PowerSource. This section provides steps for configuring the scheduler node for the report queue.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close